|
|
|
|
 |
Industrial Dust Collector Customer Installations - Food & Grain Industry
A 4,500 cfm Aerodyne unit recovers high-
protein animal feed at a Midwest plant |
 |
Toledo, Ohio:
This Horizontal SplitStream Industrial Dust Collector operates off of a cereal plant air dryer helping the plant
to meet local and state air pollution code requirements. A mix of dry and wet gases are collected
with no product buildup on the interior walls of the collector. The unique capability to install
the SplitStream Dust Collector horizontally allowed this unit to be placed between the dryer and the plant ceiling,
requiring no insulation or structural change to the building. |
This horizontal industrial dust collector replaced a bag house collector on a dryer
in a Canadian tobacco processing plant. The replacement resulted in no
loss of efficiency and greatly decreased maintenance costs. With no bags to
replace, no moving parts, and no expensive valves or compressed air systems,
the Aerodyne provided a tremendous savings in maintenance cost.
This 10,000 cfm dust collector unit gathers approximately 400 pounds of dust per shift. The
sticky, coarse material does not adhere to the collector walls because of the
powerful secondary air stream that sets a centrifugal action along the collector
walls. |
|
This Horizontal SplitStream™ Dust Collector installed between the
ceiling and a dryer at a cereal plant shows the space saving
benefits of the Aerodyne design. A typical vertical cyclone
would have required major structural changes to the building.
A huge expense was avoided with the selection of the Horizontal SplitStream Dust Collector. |
These three 6,000 cfm Aerodyne industrial dust collectors operate at negative
pressure in an Iowa grain processing plant. They have effectively
eliminated visual discharge from a distillers grain dryer stack,
resulting in the recovery of valuable product at a rate of 11 to 15
pounds per hour. |
|
This Aerodyne industrial dust collector is installed at a grain
processing plant in Iowa. Three other Aerodyne dust
collectors are installed at this plant on another
process line. |
Installed at a Midwestern feed plant, this Aerodyne SplitStream™ Dust Collector separates grain dust from air at a rate of 4,500 cfm |
See more Industrial Dust Collector Customer Installations.
|
 |
|
|
|
| |
| |
Aerodyne l Chagrin
Falls, Ohio l (800)
358-7546
|
|
|
| |
|
|
| |
|
|
|
|
|
|
|
